A & C Metals Logo
 
steel sheet coil strapping
 
   
STEEL STRAPPING
FLAT IN COIL
 Top
Painted and Waxed
to ASTM D-3953, Type I, Finish A
              Size in
              Inches		 Average Break
Strength in Lbs.		 Ft.
Per Lb.		 Lbs. Per
1000 Ft.
REGULAR DUTY* — Oscillated Wound
      1/2  x  .020 1180 29.42 34.00
      5/8  x  .020 1470 23.53 42.50
      3/4  x  .015 1340 26.15 38.25
      3/4  x  .020 1770 19.61 50.99
HIGH TENSILE* — Oscillated Wound
      3/4  x  .023 2470 17.10 58.64
      3/4  x  .025 2675 15.69 63.74
HIGH TENSILE — Ribbon Wound
      3/4  x  .029** 3325 13.50 75.19
      3/4  x  .031** 3305 12.65 79.04
   1-1/4  x  .029* 5400   8.10 123.3    
  * 105# average coils
** 75# average coils
 
 
1 Disclaimer: All technical data throughout this site is given only as an indication of what may be expected and should under no circumstances be used in specifying the raw materials. The technical data throughout this site has been obtained from a variety of sources we believe to be accurate, but is NOT GUARANTEED. A & C Metals - Sawing, Inc. assumes no liability whatsoever for the use of or reliance upon this information.
  ©   A & C Metals - Sawing, Inc. — All Rights Reserved. | Terms and Conditions | Privacy Policy